JVC LT-37DV1BJ Instructions Manual page 15


Set antenna power
Confirm that the aerial power supply is set to "Off". Select "On" only
when using an aerial which requires external power. (P. 8)
>>>>> Antenna Power
Step 5: Please select Antenna Power
On
Off

Start auto scan
Register channels
>>>>>> Auto Scan
Step 6: Auto Scan will start when "Start" is selected
Start
Cancel
>>>>>> Auto Scan
Scan Completed
Digital
13 Services Found
Analogue
14 Services Found
100%
If you cannot register channels, refer to "When you cannot watch TV

channels" (P. 14).
You can edit the channels after the initial settings. For details, refer to

"Edit PR" (P. 38). To edit PR
Some digital channels cannot be watched on this TV. For details,

refer to page 45.
1 select
2 set
>>>>>> Auto Scan
Digital
13 Services Found
Analogue
1 Services Found
51%
Æ
Getting started

Finish
To the previous screen

If the "Menu Language" does not appear or if you wish to make changes

later, refer to "Factory Setting" (P. 39) or "Retuning" (P. 39) for channel
settings.
When you cannot watch TV channels

Check the following points
Is the TV connected correctly to the aerial?

Change the direction of the indoor aerial.

Note
You can check the broadcast signal level of the channel you

are watching. For details, refer to "Signal Check" (P. 39).

Set digital channels using "Factory Settings". For details, refer to
"Factory Settings" (P. 39)
If you still cannot watch digital channels after following the steps
above, there may be a problem with your aerial or its cable. Or, the
signal may be too weak.
Basics Advanced
Æ
Consult your retailer
Æ
Etc.