Configuring Your Remote Control - JVC LT-32DP9BU Instructions Manual

Configuring your remote control

You can configure your TV's remote control to operate your other devices.
Setting your remote

Turn on the device manually.

Switch the remote control mode to a mode
that matches your device. Refer to the
table on the right to select an appropriate
mode.
The indicator lights for 3 seconds each time the

GUIDE
TOP MENU
remote control is operated.

Find the remote control code for your
device according to its brand from the
"Remote control codes" list. (Refer to
DTV ATV RADIO
P. I - X at the back of this manual.)
GUIDE
LCD
TV STB
AUDIO DVD

Set the remote control code.
Press and hold Enter four digit
number
The indicator will unlit for a seconds after entering the four digit remote

control code number.

Point the remote control at your device, press
confirm that your device is turned off. If your device does
not respond, try entering another available code.
Note
If your device does not respond, try all the available codes for the device's

brand.
If none of the code works, or the brand is not listed, refer to "Using the

search code function" (P. 25).
MODE Applicable devices
TV JVC brand only
STB Cable Set Top Box, Cable/PVR Combination,
Satellite Set Top Box, SAT/PVR Combination
DVD
DVD, Blu-Ray DVD, HD DVD, DVD-R, Home
Theater in Box, TV/DVD Combination
AUDIO Amplifier, Receiver, Home Theater in Box

Release the button
and