Related Manuals for URC MX-1200
Summary of Contents for URC MX-1200
- Page 1 Order Number : GETEC-C1-11-132 FCC Part 15 subpart C 1 / 1 Test Report Number : GETEC-E3-11-056 Page APPENDIX I : USER’S MANUAL EUT Type: RF REMOTE CONTROLLER FCC ID.: OZ5URCMX1200...
- Page 2 MX-1200 Color Touch screen Owner’s Manual...
- Page 3 Congratulations on your choice! MX-1200 Owner's Manual © 2011 Universal Remote Control, Inc. The information in this manual is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Universal Remote Control, Inc.
-
Page 4: Table Of Contents
Using the TRC-1200 Connecting the Battery Pack Using the Charging Base Displaying the Settings Screen Sleep Settings System Brightness Power Button Light Date and Time Calibration Pickup Settings Sound Factory Default Exit Maintaining Your MX-1200 Specifications USA Limited Warranty Statement... -
Page 5: Congratulations
The MX-1200 can communicate directly to RF base stations, such as the MRF-350 and the MRF-260. It also natively communicates to URC Lighting via 418MHz RF. This gives the MX-1200 the ability to control your system without being in direct line-of-sight. -
Page 6: Using The Trc-1200
OUCH CREEN Using the MX-1200 The MX-1200’s main pages display the activities and devices in your system. Press the main page button to see what your choices are. Large systems may have more than one page. Press either of the Page buttons if you don’t see all your devices. -
Page 7: Connecting The Battery Pack
Unlock the rear cover by pressing down on the spring lock at the top of the cover. Remove the cover. For shipment from the factory, the battery is left out of the MX-1200. Place the battery into the battery compartment, making sure you align the contacts on the battery to the contacts on the MX-1200. -
Page 8: Displaying The Settings Screen
You can enter the settings menu by pressing and holding the MAIN and OK button for three seconds. Once there, if you do not press any button on the Settings screen, the MX-1200 will timeout after 30 seconds and return to the previous setting or Main screen. -
Page 9: Sleep Settings
MX-1200 C OLOR OUCH CREEN Sleep Settings Conserve energy by configuring the MX-1200 to fall asleep after a specified amount of time. Select an amount of time by adjusting the slide bar. System The System Information screen displays data about your MX-1200's operating system, memory etc. -
Page 10: Button Light
PDA stylus to do this. Do not attempt to calibrate using your fingers. Date and Time You can set your MX-1200 to only turn on when touched, or every time you move it. Adjust the pickup sensor level by sliding the bar to the desired percentage. -
Page 11: Sound
Factory Default WARNING! Only use this button when instructed to by Technical Support. It resets the memory of the MX-1200 to the factory condition. All your programming will be lost! Exit When you have finished adjusting Settings, simply tap the Exit button to return to normal operation. -
Page 12: Maintaining Your Mx-1200
Keep it away from extreme cold or heat. The MX-1200 is not waterproof. Do not use it in any location that is damp or wet. If you spill water on it, take out the battery pack and let the MX-1200 dry for 48 hours before powering it up again. -
Page 13: Usa Limited Warranty Statement
MX-1200 C OLOR OUCH CREEN USA Limited Warranty Statement Your Universal Remote Control, when delivered to you in new con- dition, is warranted against defects in materials or workmanship as follows: UNIVERSAL REMOTE CONTROL, INC. warrants this prod- uct against defects in material or workmanship for a period of one (1) year and as set forth below. - Page 14 MX-1200 C OLOR OUCH CREEN LIMITATION OF REMEDIES UNIVERSAL REMOTE CONTROL SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY OR CONDI- TION ON THIS PRODUCT. IN NO EVENT SHALL UNIVERSAL...
- Page 15 MX-1200 C OLOR OUCH CREEN Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 17 500 Mamaroneck Avenue, Harrison, NY 10528 Phone: (914) 835-4484 Fax: (914) 835-4532 www.universalremote.com Version 8.18.11...
Need help?
Do you have a question about the MX-1200 and is the answer not in the manual?
Questions and answers