Inalto IDW42CS User Manual page 20

How to Drain Excess Water From Hoses How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink. container that is held outside and lower than the sink.
Water Outlet Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed. Ensure that the water drain hose is not kinked or squashed.
Extension Hose Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose. If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced. It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection Syphon Connection
The waste connection must be at a height less than 1000 mm (maximum) from the bottom of the dish. The waste connection must be at a height less than 1000 mm (maximum) from the bottom of the dish.
The water drain hose should be fixed . The water drain hose should be fixed .
Start of Dishwasher Start of Dishwasher
The following things should be checked before starting the dishwasher. The following things should be checked before starting the dishwasher.
1 1
The dishwasher is level and fixed properly The dishwasher is level and fixed properly
2 2
The inlet valve is open The inlet valve is open
3 3
Fill hose connections are fully tightened and not leaking Fill hose connections are fully tightened and not leaking
4 4
The wires are tightly connected The wires are tightly connected
5 5
The power is switched on The power is switched on
6 6
The inlet and drain hoses are knotted The inlet and drain hoses are knotted
7 7
All packing materials and printings should be taken out from the dishwasher All packing materials and printings should be taken out from the dishwasher
Attention: Attention:
After installation, please make sure to keep this manual. After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users. The content of this manual is very helpful to the users.
20
15 15
9
B