Installing The Belt Clip; Installing The Cap Over The Speaker/ Microphone Jacks - Kenwood TK-D240V User Manual

◆ The battery pack life is over when its operating time decreases even
though it is fully and correctly charged. Replace the battery pack.

INSTALLING THE BELT CLIP

CAUTION
◆ Do not use glue which is designed to prevent screw loosening
when installing the belt clip, as it may cause damage to the
transceiver. Acrylic ester, which is contained in these glues,
may crack the transceiver's back panel.
INSTALLING THE CAP OVER THE SPEAKER/
MICROPHONE JACKS
Install the cap over the speaker/ microphone jacks when not
using an optional speaker/ microphone or headset.
Note:
◆ To keep the transceiver water resistant, you must cover the speaker/
microphone jacks with the supplied cap.
If necessary, attach the belt clip
Belt clip
using the two supplied M3 x 8 mm
screws.
Note:
◆ If the belt clip is not installed, its
1 Place the cap over the jacks so that the
locking tabs insert into the transceiver
grooves.
2 While holding the cap in place, push it
towards the bottom of the transceiver
until the tabs on the cap click into place.
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
15