Motion; Alarm - EverFocus EVS200AW-W User Manual

4.7.2 Motion

Motion Detection
First, select the channel for motion detection setting.
User can define the motion area to be detected by left clicking the mouse to draw
lines. Every click is an end point of the line. When the detection area is formed,
double click the mouse to have all the lines connected. To remove the selection,
simply right click the mouse, the selected polygon will be deleted.
Press All Areas to have the entire screen selected for motion detection.
Press Clear to clear all selections.
There are 5 motion trigger areas, which can be distinguished by 5 different colors.
Check Enable checkbox to enable event action.
For each of them, you can set the event action to be activated. Event action can be
set in "Event" section.
Moreover, you can set the Sensitivity level for motion triggered by selecting from
1 (low), 2, 3, 4, 5, 6, 7, 8, 9 to 10 (high).

4.7.3 Alarm

31
EVS200A/EVS200AW