Using The Blender - Philips HR2094/00 Manual

EnglisH
10

using the blender

1 Put the ingredients in the blender jar.
2 Place the lid on the blender jar.
Close the lid by pushing it down firmly.
3 Insert the measuring cup into the opening in the lid.
4 Select a speed by turning the control knob or push one of the quick-
select buttons (see section 'Control knob').
Do not let the appliance run for more than 3 minutes at a time. If you
have not finished processing after 3 minutes, switch off the appliance and
let it cool down to room temperature before you let it run again.
5 Always switch off the appliance by setting the control knob to OFF
before you open the lid.
after using the blender
1 Unplug the appliance.
2 Remove the lid with the measuring cup from the blender jar.
3 Remove the blender jar with the unit interface attached from the
motor unit.
4 Unscrew the blade unit interface from the bottom of the blander jar.
5 Always clean the removable parts immediately after use.
tips
- Cut meat or solid ingredients into smaller pieces before putting them
in the blender jar.
- Do not process a large quantity of solid ingredients at the same time.
Process these ingredients in a series of small batches instead.
- To make tomato juice, cut the tomatoes in four and drop the pieces
through the opening in the lid onto the rotating blades.
measuring cup
You can use the measuring cup to measure ingredients or to prepare
mayonnaise.
To prepare mayonnaise, you can punch a hole in the middle of
,
the bottom of the measuring cup with a knife or another sharp
implement to use the measuring cup as a funnel for adding oil when
preparing mayonnaise. The oil should be added very slowly to obtain
the right consistency. Let the blender operate at a low speed when
preparing mayonnaise.
Note: Once you have punched a hole in the measuring cup, it cannot be used
as a measuring cup anymore.