Network Connection And Settings (Snh-V6430Bnh) - Samsung SNH-V6430BN User Manual

Network Connection and Settings
(SNH-V6430BNH)
Precautions
The cable connecting the router to the camera should have a length of 70m or
less (based on CAT5e LAN cable)
The wireless network access may fail, depending on the communications
environment.
In this case, a wired connection is recommended.
For details about the network settings and password, contact your network
administrator or service provider.
For a specific Internet service requiring user authentication, you may not access
the service. If this is the case, contact the service provider.
Do not access the unauthorized network.
The farther the distance from the Wireless Access Point, the longer time the
network connection may take.
If you fail to access the selected wireless network, try a different Wireless
Access Point to make access.
For more information about the router or the wireless connection, refer to the
documentation of the router or contact the router manufacturer.
If the camera is connected to a multiple-Wireless Access Point network
environment, some video packets may be lost, depending on the network traffic
load.
According to the network policy (blocking UDP) of the service provider, the video
transmission can be limited to 7 minutes.
For more details, refer to the descriptions on page 28, <Relay Mode>.
In addition to the above two situations, you may encounter a network delay or
interruption due to the network conditions.
Some hubs can have compatibility issues.
Connecting via network cable
If a wireless router is not available, connect a home router directly to the PoE
adapter to which the camera is connected using a LAN cable.
1.
Turn the power on and the LED will turn red. The red light will flicker when
bootup is complete.
2.
As shown in the figure below, LAN
<Router>
3.
When the camera is connected to the router, the LED turns blue.
(Connection standby time: 30 seconds maximum)
If the LED does not turn blue, return to Step 2 and confirm that all steps were
performed correctly.
4.
The status LED will became steady green once the camera is connected to
server.
n
It is recommended to set the router to DHCP(Dynamic Host Configuration Protocol)
server.
If you want to use static IP address, please refer to <Wired Network> on page 30.
If the router's UPnP is not set, then you might be connected in relay mode.
The settings may differ depending on the connected Broadband Router model.
For more information, refer to the user manual of the applicable router.
02
Internet Service
19