Samsung SNH-V6430BN User Manual page 15

When installing on a concrete wall
3.
Fix the bracket on the wall using screws and
anchors. First, mark the wall on which the
camera is to be installed as shown in the
figure.
4. On the mark, drill a hole to a depth of about
3cm in the wall using a drill bit and drill with a
5mm diameter for concrete. Remove any
debris remaining in the hole after drilling.
J
Use caution when drilling to avoid injury.
5.
Insert an anchor in each of the 2 holes for the
screws, then hit the back of the anchor with a
hammer or a rubber mallet until it is
completely inserted.
6.
Insert a screw in each of the 2 holes in the
wall, and tighten the screws using a Phillips
screwdriver.
7.
Connect the adapter plug to the power
terminal of the camera.
8.
If the bracket hinge becomes loose, remove the
rubber cover and tighten the screw using a
screwdriver.
Adjusting the camera angle
1.
Place the camera stand on a flat
surface.
2.
Adjust the camera's shooting angle as
appropriate.
n
If the bracket hinge becomes loose,
remove the rubber cover and tighten the
screw using a screwdriver, then adjust the
direction of the camera.
02
15