Troubleshooting - MBM FO0601 Operation Manual

7. Troubleshooting

Trouble
The paper does
not feed properly
The machine does not
operate even after the
START/STOP key is
pressed
Wrinkles appear on
the paper
Improper fold
position
Printed paper
(13 lbs bond or
lighter)
is not folded.
Possible Cause
Recently printed paper sticks
together
Stains on the paper separator
Stains on the paper feed rubber
roller
The paper separator is worn out
The volume of the paper stacked on
the paper feed table is not enough
Paper jam inside the unit
Recently printed paper sticks
together
Stains on the paper separator
Stains on the paper feed roller
Stains on paper fold rollers
Tables 1 and 2 are not properly set
Paper jam in Table 1 and 2
The length of the paper is not
standard size
The surfaces of the fold rollers are
covered with dust or ink, causing
them to be slippery
Low room temperature
Jog the paper sufficiently. Make sure that
the ink is dry.
Clean the paper feed separator using
appropriate cleaner.
Clean the dust or ink on the paper feed
roller using appropriate cleaner.
Install a new paper separator.
Add more paper to the feed table – at least
20 sheets or more.
Detach Table 1 and 2 and remove the
jammed paper from the unit.
Jog the paper sufficiently. Make sure that
the ink is dry.
Clean the paper separator using an
appropriate cleaner.
Clean the dust or ink on the paper feed
roller using an appropriate cleaner.
Clean all four fold rollers using an
appropriate cleaner.
Reset properly.
Detach Table 1 and 2 and remove the
jammed paper.
Measure the length of the paper and adjust
using the fine adjustment knob.
Clean all four fold rollers using an
appropriate cleaner.
Operate the machine in a
climate-controlled environment. Paper
should be at room temperature before
folding. Paper stored below 53F is not
recommended.
18
Measures