Error Indications, Situations, And Measures - MBM FO0601 Operation Manual

5.13 Error indications, situations, and measures

The machine will automatically stop in the following cases
Indication Situation
① The Start/Stop key was pressed
without sheets of paper.
②The Start/Stop key or the Test key
was pressed with the paper feed
table lever shifted up.
③ Sheets of paper ran out in the
middle of operation in countdown
mode.
①A paper feed slip occurred.
②A paper jam occurred in folding
cassette 1 or 2
①The paper ejection table is full of
sheets of paper.
②A paper jam occurred in the paper
ejection unit.
③The paper ejection photosensor is
contaminated.
①The safety cover is open.
②Folding cassette 1 is not properly
set.
③Folding cassette 2 is not properly
set.
①A paper jam occurred in folding
cassette 1 or 2.
②The speed is low.
A paper jam occurred due to a low
speed.?
16
Measure
①Set sheets of paper.
②Shift down the paper feed table
lever.
③Add sheets of paper.
①Clean or replace the paper
separator and the paper feed rubber
rollers. See "6 maintenance" on
page 15
②Detach folding cassette 1 or 2, and
remove the jammed paper.
①Remove the sheets of paper in the
paper ejection unit.
②Remove the jammed paper.
③Clean the paper ejection
photosensor.
See "6 maintenance" on page 15
①Close the safety cover.
②Reset folding cassette 1.
③Reset folding cassette 2.
①Detach folding cassette 1 or 2, and
remove the jammed paper.
②Increase the speed.