Troubleshooting - MBM 206M User Manual

http://www.monomachines.com

(8) Troubleshooting

Trouble
The paper does
not feed properly
The machine does not
operate even after the
START/STOP key is
pressed
Wrinkles appear on
the paper
Improper fold
position
Printed paper
(13# or lighter)
cannot be folded
http://www.monomachines.com
For More Info
Click Here --->
Possible Cause
Paper sticks just after it is printed
Stains on the paper separator
Stains on the paper feed rubber
roller
The paper separator is worn out
The volume of the paper stacked on
the paper feed table is not enough
Paper jam inside the unit
Paper sticks just after it is printed
Stains on the paper separator
Stains on the paper feed roller
Stains on paper fold rollers
Table 1 and 2 are not properly set
Paper jam in Table 1 and 2
The total length of the paper is not
standard size
The surfaces of the fold rollers are
covered with dust or ink, causing
them to be slippery
Low room temperature
16
Measures
Jog the paper sufficiently. Make sure that
the ink is dry.
Clean the paper feed separator using
approved cleaner.
Clean the dust or ink on the paper feed
roller with approved cleaner.
Install a new paper separator.
Add more paper to the feed table – at least
20 sheet or more.
Detach Table 1 and 2 and remove the
paper from the unit.
Jog the paper sufficiently. Make sure that
the ink is dry.
Clean the paper separator using the
approved cleaner.
Clean the dust or ink on the paper feed
roller with the approved cleaner.
Clean all four fold rollers using approved
cleaner.
Reset properly.
Detach Table 1 and 2 and remove the
jammed paper.
Measure the total length of the paper and
adjust using the fine adjustment knob.
Clean all four fold rollers using the
approved cleaner.
Operate the machine in a
climate-controlled environment. Paper
should be a room temperature before
folding. Paper stored below 53F is not
recommended.