Saeco HD8944/08 Operating Instructions Manual page 51

46
maCHIne WarnInGS
Help Message Displayed
EMPTY DRIP TRAY
ROTATE THE MILK CARAFE DISPENSING
SPOUT INTO BREWING POSITION
ESC
ROTATE THE MILK CARAFE DISPENSING
SPOUT INTO RINSING POSITION
ESC
PLACE MILK CARAFE
IN ITS HOUSING
ESC
17/05/09
USER
MENU
SELECTED
USER
04:17 pm
17/05/09
USER BEVERAGE
MENU MENU
SETTINGS
SELECTED
USER MENU
04:17 pm
RESTART TO SOLVE
THE PROBLEM
(E xx)
How to Reset the Message
Open the service door and empty the drip tray located under the brew
group.
Warning: If this operation is performed when the machine is
on, it will record the used grounds drawer emptying and will
reset the counter; therefore, it is necessary to empty the coff ee
grounds as well.
A beverage with milk has been selected. The machine requires the carafe
handle spout to be placed into dispensing position.
Press the button "ESC" to cancel the selection.
The carafe rinse function has been selected.
Press the button "ESC" to cancel the selection.
The selected operation requires the milk container for brewing. Insert the
container in the machine as specifi ed in the manual.
Press the button "ESC" to cancel the selection.
perform a descaling cycle on the machine.
BENERAGE
When this message is displayed, it is still possible to use the machine, but
MENU
its correct operation might be compromised.
Damages caused by failure to descale the machine are not covered by
warranty.
SETTINGS
MENU
Flashing red light. Machine in Stand-by.
The Stand-by settings can be changed.
Press the "
An event has occurred which requires the machine restart. Take note of
the code (E xx) shown at the bottom.
Switch off the machine, wait 30 seconds and then switch it on again. If
the problem persists, contact the service centre.
" button.