Table of Contents
Advertisement
USING YOUR ION POWER PACK BATTERY
INSTALLING YOUR ION POWER PACK BATTERY
Slide the ION Power Pack Battery into the slot on the back of
TAKE CHARGE OF
the handheld vacuum.
YOUR RUNTIME:
To remove, pinch the release tab and slide the ION Power Pack
Battery out of the handheld vacuum.
Upgrade to the 2X ION
Power Pack System
CHARGING YOUR ION POWER PACK BATTERY
(additional battery
Using the ION Power Pack Battery Charger
and charging dock),
Connect the ION Power Pack Battery Charger to the port on
purchase additional
the side of the ION Power Pack Battery, then plug the charger
batteries, and discover
into a wall outlet. The ION Power Pack Battery can be charged
more charging options
whether it is inside or outside the handheld vacuum.
by visiting sharkclean.
Using an ION
com/batteries
Power Pack Battery
Charging Dock*
Connect ION Power
RECYCLING YOUR ION
Pack Battery Charger
POWER PACK BATTERY
to the Charging Dock.
When your ION Power Pack
Place power pack onto
Battery needs to be replaced,
dock, then connect
dispose of it or recycle it
charger to wall outlet.
in accordance with local
*Not included in all models
ordinances or regulations. In
LED BATTERY POWER METER
some areas, it is illegal to place
In Use
spent lithium-ion batteries in
As the ION Power Pack discharges, its 3 LED lights will
the trash or in a municipal solid
gradually turn off in sequential order. When less than 5% of
waste stream. Return spent
power packs to an authorized
charge remains, the bottom LED light will flash, indicating a
recycling center or to retailer
charge is needed.
for recycling. Contact your
local recycling center for
information on where to drop
off the spent power pack.
NOTE: ION Power Pack
takes approximately 3.5 hours
for full charge.
Charging
As the ION Power Pack Battery charges, the lights will first blink
and then illuminate steadily, in sequential order. All 3 lights will
glow steadily upon receiving a full charge, and then turn off after
a short period. This preserves long-term battery life and allows
the battery to remain connected to the charger even after
reaching full charge.
7
1-800-798-7398
1
Full
Mid
Low
Nearly
Charge
Charge
Charge
Empty
Low
Nearly
Mid
Charge
Full
Charge
ASSEMBLING YOUR VACUUM
2
No
Charge
1
Insert the wand into the floor nozzle,
pressing it in until it clicks securely into
place.
Full
Charge
STEP 1
CLICK
2 Insert the handheld vacuum into the top
of the wand, pressing it in until it clicks
securely into place.
STEP 2
CLICK
8
s h a r kc l e a n . c o m
Advertisement
Table of Contents
