Panasonic HC-WXF1 Operating Instructions Manual page 109

3
(When [Microphone Gain] is selected in Step 2)
Select an item.
[Normal]:
[Attenuate]:
(When [Frequency Response] is selected in Step 2)
Touch /
≥ Before recording, check the effect you have selected with a headphone set, etc.
≥ The high frequency range (dB) and low frequency range (dB) can be adjusted.
≥ If noises such as the sound caused by the wind bother you, set the low frequency range to
[LowCut].
≥ To end the adjustment, touch [EXIT].
(When [Directional] is selected in Step 2)
Select an item.
[SURROUND]/[STEREO]:
[MONO]:
4 Touch [EXIT].
appears on the screen.
≥
≥ Depending on the recording condition or sound quality, the desired effect may not be achieved.
≥ The setting becomes [Auto] when you have connected an external microphone or audio device
* You can connect audio equipment when using the
≥ (When [Music] or [Festival] is set)
The volume of the recorded sounds may be lower than that of the sounds recorded with [Auto].
≥ (When [Speech] or [Nature] is set)
Sounds recorded with these effects are less realistic than those recorded with [SURROUND] or
[STEREO MIC] in [MIC SETUP].
[5.1ch/2ch]
You can switch the channel number setting of the built-in microphone.
≥ Set [REC FORMAT] to [AVCHD].
: [RECORD SETUP] # [5.1ch/2ch] # desired setting
MENU
[5.1ch]:
[2ch]:
≥ [2ch] will be selected in the following cases:
j When [REC FORMAT] is set to a setting other than [AVCHD]
j When you have connected an external microphone or audio device
* You can connect audio equipment when using the
Adjusts the sound quality automatically.
Records sounds of very loud scenes at appropriate volume.
to adjust.
Records sounds with the setting of [MIC SETUP] ([SURROUND] or
[STEREO MIC]).
Records sounds from all directions without setting specific
directivity.
(l 102)
Records with the 5.1ch.
Records with the 2ch.
WXF1 series/
WXF1 series/
- 109 -
VXF1 series.
*
VXF1 series.
*
.