Table of Contents
Advertisement
To clean the door gasket, refer to the
general information about cleaning.
11.4 Removing the shelf
supports / catalytic panels
To clean the oven, remove the shelf
supports / catalytic panels.
CAUTION!
Be careful when you remove
the shelf supports. The
catalytic panels are not
attached to the oven walls
and can fall out when you
remove the shelf supports.
1. Pull the front of the shelf support
away from the side wall. Hold the
rear shelf runners and catalytic panel
in place with the other hand.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must
point to the front.
11.5 Catalytic cleaning
The cavity with a catalytic coating is self-
cleaning. It absorbs fat.
Before you turn on the catalytic cleaning:
• remove all the accessories .
• clean the oven floor with warm water
and mild detergent.
2
• clean the inner door glass with warm
water and soft cloth.
1. Set the function
2. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
3. Turn off the oven.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.6 Removing and installing
door
The oven door has two glass panels.
You can remove the oven door and the
internal glass panel to clean it. Read the
whole "Removing and installing door"
instruction before you remove the glass
panels.
The oven door may close if
you try to remove the
internal glass panel before
you remove the oven door.
CAUTION!
Do not use the oven without
the internal glass panel.
1. Fully open the door and find the
hinge to the right side of the door.
2. Use a screwdriver to lift and turn fully
the right side hinge lever.
3. Find the hinge to the left side of the
door.
ENGLISH
23
.
Advertisement
Table of Contents
