Table of Contents
Advertisement
Available languages
Available languages
activated. Switch off the childproof lock by pressing the Key-lock button and holding it down
for more than 3 seconds once again.
VENTILATION INDICATOR
When the VENT indicator starts blinking, this is a sign that the room
is not vented sufficiently. If you do not provide additional ventilation,
the heater will switch off automatically after some time. If the
indicator continues blinking after extra ventilation, please contact your
indicator light continues blinking after extra ventilation, please
contact your dealer.
dealer.
FUEL INDICATOR
When the Fuel Indicator lights up, it means that there is only fuel left
When the Fuel indicator lights up, there is enough fuel left for
for 10 more minutes. The count-down of the remaining heating time
another 10 minutes of heater use. The count-down of the remaining
heating time can be seen in the information display. Every two
can be seen in the Digital indicator. Now you have two options:
LC-32F (GB) 12.9.3 11:39 AM ページ 9
minutes an alarm signal is sounded, warning you to refill the
removable tank. If you do not react, the heater will extinguish by
you remove the removable fuel tank and refill it outside the living
itself. The heater will also sound a warning signal, when it switches off. The Fuel indicator will
room or
blink, while four lines are blinking in the information display. You can stop this by pressing
the
you push the Extension key. By pushing this key, the remaining heating time will extend
button once.
to 60 minutes. The heater will automatically switch back to its lowest position. In the display
Once the heater has used up all its fuel and extinguished, it will take some time, after the
the number 60 will appear, which will decline to 10. At the arrival of 10, you will hear an alarm
refill, before the heater is completely ready for use again.
LC-32F (GB) 12.9.3 11:39 AM ページ 9
AUTOMATIC CLEANING MODE
signal every two minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal, when it switches
LC-32F (GB) 12.9.3 11:39 AM ページ 9
off. The Fuel Indicator will blink, while four lines (--:--) are blinking in the Digital indicator. You
When the heater has been burning continuously for two hours at its highest setting, the
can stop this by pressing the
burner will automatically start an autoclean procedure. The display will show the
autocleaningcode
Once the heater has used up all its fuel and extinguished, it will take some time, after the refill,
which the heater will burn at its lowest setting, while the burner autocleans. When the burner
AUTOMATIC CLEANING MODE
before the heater is completely ready for use again.
is clean again, the heater will automatically switch back to the highest setting again.
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest setting, the
burner will automatically start an autoclean procedure. The display will show the
TURNING OFF HEATER
When the heater has been burning continuously for two hours at its highest setting, the
autocleaningcode
burner will automatically start an autoclean procedure. The display will show the
which the heater will burn at its lowest setting, while the burner autocleans. When the burner
autocleaningcode
is clean again, the heater will automatically switch back to the highest setting again.
which the heater will burn at its lowest setting, while the burner autocleans. When the burner
is clean again, the heater will automatically switch back to the highest setting again.
TURNING OFF HEATER
TURNING OFF HEATER
While heater is burning, press power switch to "OFF" position. This will extinguish heater and
Press
the key. This will extinguish heater and ON/OFF Lamp on the indicator panel will go
ON/OFF Lamp on the indicator panel will go out.
out.
The circulation fan motor will operate further, for approximately 90 seconds to assist in
cooling down heater.
NEVER : Turn heater off by disconnecting the heater plug from the main elecrical supply.
While heater is burning, press power switch to "OFF" position. This will extinguish heater and
DO NOT : Restart your heater for at least ten minutes.
ON/OFF Lamp on the indicator panel will go out.
While heater is burning, press power switch to "OFF" position. This will extinguish heater and
The circulation fan motor will operate further, for approximately 90 seconds to assist in
key once more.
running back to
8
running back to
running back to
10
. The procedure takes 5 minutes, during
. The procedure takes 5 minutes, during
. The procedure takes 5 minutes, during
Advertisement
Table of Contents
