Outdoor Unit Dip-Switch Setting - Hisense AVW-38UCSC Installation & Maintenance Manual

Install a multi-pole main switch with a space of 3.5mm or more between each phase.
7. Outdoor Unit Dip-Swtich Setting
Turn off all power switch before setting Dip-Switch,else Dip-Switch is of no effect.
Follow this table setting Dip-Switch,
ALL OFF:Shipment Set ALL OFF: Shipment Set
Test Run(Cool) Test Run(Cool)
Test Run(Heat)
Forbid Compressor Stop Forbid Compressor Stop
G
Communication Setting
It is necessary to set
Ref. cycle system No.
and terminal resistor
connect to Hi-NET system.
G
Setting Ref.cycle system No.
Setting Ref.cycle (DSW4)
High Digit Setting
Ten
A Bit
symbol denote the position of Dip-Switch contact joint.
ALL OFF:Shipment Set
Optional Function Setting
Input Power Setting
Capacity Setting
AVW-38UCSC
AVW-48UCSC
22
Ref. Cycle No.
Setting
Input Power Setting
AVW-54UCSC
I.U.is located higher
than O.U.(>20m)
Communication
Setting
Pipe length Setting
Shipment
O.U.is located higher O.U.is located higher
than I.U.(>25m)