Table of Contents
Advertisement
Removing the glass from the door
Open the oven door so you are able to access the screws on
the edge of the oven door (Fig. 6.4).
Remove the 2 screws (Fig. 6.4).
Remove the plate from the top od the oven door (Fig. 6.5).
Carefully remove the inner galss from the door and place ona
soft, flat surface.
Clean the glass with soap and water and dry with a soft cloth.
Reassemble the door in the reverse order.
Refitting the Oven Door
To refit the door, slide the hinges back into their slots. Rotate
the locking 'U' clips back to fit onto the hinges.
Oven
DO NOT use steel wool, oven cleaning pads, or any
n
other materials that will scratch the surface.
Changing the bulb
Back light
Fig. 6.6
You can buy a replacement bulb (which is not covered under
the warranty) from a good electrical shop. Ask for a 15 W
– 230 V lamp, FOR OVENS. It must be a special bulb, heat
resistant to 300 °C.
Turn off the power at the circuit breaker.
n
Before removing the existing bulb, turn off the power supply
and make sure that the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the protective cover by turning counter-clockwise. It
may be very stiff. We recommend that you wash and dry the
glass cover at this point.
Carefully unscrew the old bulb and insert the new bulb.
Screw back the bulb cover. Turn on the circuit breaker and
check that the bulb now lights. Refit the protective cover.
IMPORTANT
Never use screwdrivers or other utensils to remove
n
the light cover. This could damage the enamel of the
oven or the lamp holder.
Remove only by hand.
n
Never replace the bulb with bare hands as
n
contamination from your fingers can cause
premature failure. Always use a clean cloth or
gloves.
Please note: The bulb replacement is not covered by
n
your guarantee.
ArtNo.324-0005 Oven light bulb
14
Fig. 6.4
Fig. 6.5
Fig. 6.6
Advertisement
Table of Contents
