Table of Contents

Advertisement

OPERATION

Figure 1
C
!
NOTE:
Always ensure that the appliance is in an upright
position before operating the unit.
!
NOTE:
When the cassette is used in an environment
where background noise is very low, it may be possible to
hear a sound which is related to the operation of the flame
effect. This is normal and should not be a cause for con-
cern.
!
NOTE:
Always ensure that the appliance is in a level
position.
The manual controls for the cassette are located on the top
of the unit, below the control cover. (Figure 1)
A . On/Off Switch
Supplies power to the cassette.
B . Mode Selector Switch
Press once to turn on the flame effect. This will be indicated
by an audible "beep". Although the lights turn on immedi-
ately it will take 30 seconds before the flame effect starts.
Press
to put fire in to standby mode. This will be indi-
cated by one "beep".
C . Flame Intensity Control
Adjusts the intensity of the flame effect when the cassette
has been activated.
Turning the control knob clockwise to decrease the inten-
sity of the flame effect. Turning the control knob counter-
clockwise will increase the flame effect.
!
NOTE: Give the flame generator some time to react to
changes you may make on the flame control knob.
!
NOTE: When the water tank is empty the unit will turn
off after 30 seconds. See instructions under Maintenance
Section for refilling tank. When this procedure is complete,
the main lamps will illuminate but it will take 30 seconds
before the flames return.
B
A
Remote Control
Sensor
Figure 2
Standby
Button
On
Button
Battery Cover
Remote Control
The On/Off Switch must be in the 'ON' ( I ) position in order
for the remote control to operate. (Figure 2)
!
NOTE: To operate correctly, the remote control must be
pointed towards the remote control sensor.
To operate, push the ON button to turn fireplace on, push
the Standby button to turn the fireplace off.
Battery Replacement
To replace the battery:
1. Slide battery cover open on the remote control (Figure
2).
2. Install two 1.5 Volt (AAA) batteries in the battery holder.
3. Close the battery cover.
Battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for recy-
cling advice in your area.
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfi400rDfi600l690905024169090502426909050261

Table of Contents