Preparation; Assembling The Detector - Treasure Cove TC-3020 Owner's Manual

PREPARATION

ASSEMBLING THE DETECTOR

Assembling your detector is easy and requires no special tools. Just follow
these steps.
1. Slightly loosen the lock nut on the bigger stem. Insert the smaller
stem into the bigger one and tighten the lock nut.
2. Insert the latch on the top of the handle into the assembly hole on
the bottom of the control box. Then slightly push the control box in the
direction of IN marked on the handle to fix the latch in place. Secure
the control box with fixing screw properly.
Fixing screw
3. Unscrew the knob on the search coil and remove the knob connector.
Insert the stem and align the holes on the search coil bracket and the stem.
Push the connector through the holes and tighten the knob.
4. Wind the search coil cable around the stem. Leave enough slack in the
cable. Insert the search coil cable plug into the five pin jack on the front
control box's housing.
Control box
Assembly hole
latch
4