Operation; General Operating Safety; Checks Before Starting - Simplicity ZT2000 Series Operator's Manual

Zero turn rider
Hide thumbs Also See for ZT2000 Series:
Table of Contents

Advertisement

Operation

General Operating Safety

Before first time operation:
• Be sure to read all information in the Safety and Operation
sections before attempting to operate this rider and mower.
• Become familiar with all of the controls and how to stop the
unit.
• Drive in an open area without mowing to become accus-
tomed to driving the unit.
WARNING
Never operate on slopes greater than 18 percent (10°).
Select slow ground speed before driving onto a slope. Use
extra caution when operating on slopes with a rear-mounted
grass catcher.
Mow up and down slopes, not across the face, use caution
when changing directions and DO NOT START OR STOP ON
SLOPE.
WARNING
Never allow passengers to ride on the unit.
Before leaving the operator's position for any reason, lock
the ground speed levers in the START/PARK position,
engage the parking brake, disengage the PTO, stop the
engine and remove the key.
To reduce fire hazard, keep the engine, rider and mower free
of grass, leaves and excess grease. Do not stop or park rider
over dry leaves, grass or combustible materials.
Gasoline is highly flammable and must be handled with
care. Never fill the tank when the engine is still hot from
recent operation. Do not allow open flame, smoking or
matches in the area. Avoid over-filling and wipe up any
spills.
WARNING
If you do not understand how a specific control functions, or
have not yet thoroughly read the FEATURES & CONTROLS
section, do so now.
Do NOT attempt to operate the rider without first becoming
familiar with the location and function of ALL controls.
14

Checks Before Starting

• Check that the crankcase is filled to full mark on dipstick
(A, Figure 1 - located under engine cover). See the engine
owner's manual for instructions and oil recommendations.
• Make sure all nuts, bolts, screws and pins are in place and
secure.
• Adjust the seat position (B), and make certain you can
reach all controls from the operator's position.
• Fill the fuel tank (C) with fresh fuel. Refer to the engine
owner's manual for fuel recommendations.
B
A
Figure 1. Pre-Start Checks
WARNING
Do not load this zero-turn rider on a trailer or truck using
two separate ramps. Only use a single ramp that is at least
one foot wider than the width of the rear wheels of this
rider. This rider has a zero turning radius and the rear
wheels could fall off the ramps, or the rider could tip over
injuring the operator or bystanders.
C
www.SimplicityMfg.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zt274607800579

Table of Contents