1
Press MENU / DISP for 3 seconds.
2
repeatedly to until [V -
Press
or
LAST] or [V - ADJ] is displayed.
3
Turn
to select a setting:
[V - LAST] : Each time you turn on
•
the unit, the volume remains from its
previous use.
[V - ADJ] : Each time you turn on the
•
unit, the volume is at the preset level.
4
Press
to confi rm.
Store preset volume
You can turn on the unit at a preset volume.
1
Select [V - ADJ] as the start volume (see
'Select start volume' on page 24 ) .
2
Press MENU / DISP for 3 seconds.
3
repeatedly to until [A-VOL]
Press
or
is displayed.
4
Turn
to select a value: 0 - 47.
5
Press
to confi rm.
Turn beep sound on/off
Each time you press a button, the unit beeps.
You can turn off/on this beep sound.
1
Press MENU / DISP for3 seconds.
2
Press
or
repeatedly to until [BEEP
ON] or [BEEP OFF] is displayed.
3
Rotate
to select a setting:
•
[BEEP ON] : Turn on the beep sound.
[BEEP OFF] : Turn off the beep sound.
•
4
Press
to confi rm.
Turn display scroll on/off
For track information that is longer than the
display panel: you can select to cut off the
remainder of the text, or scroll to display the
full text.
CEM250-55-IFU-ENG.indd
CEM250-55-IFU-ENG.indd
25
25
Note
•
If any special characters are present in the MP3 track
name or album name, it may not display correctly on the
screen because these characters are not supported.
•
Some WMA is protected by Digital Rights Management
(DRM), it cannot be played on the unit.
•
Folders/fi les exceed the supported limit of the unit are
not displayed or played.
1
Press MENU / DISP for 3 seconds.
2
Press
or
repeatedly to until [ROLL
ON] or [ROLL OFF] is displayed.
3
Turn
to select a setting:
•
[ROLL ON] (scroll on): Auto scroll
during play.
[ROLL OFF] (scroll off): No auto
•
scroll display.
4
Press
to confi rm.
Select shock-protect setting
You can select the shock protection setting,
depending on the stability of your car and the
condition of the road.
1
Press MENU / DISP for 3 seconds.
2
repeatedly until [ESP] is
Press
or
displayed.
3
Turn
to select a setting:
[ESP 12] : select this when the road is
•
smooth and there are few bumps.
[ESP 45] select this when the road is
•
bumpy and unstable.
4
Press
to confi rm the selection.
Reset
You can reset the unit to its default setting.
1
Detach the front panel (see 'Detach the
front panel' on page 2 7 ) .
2
Press the reset button by using a ball-point
pen or a similar tool.
EN
25
2008-10-28
2008-10-28
10:28:24
10:28:24