Biomedical Life Systems BioStim NMS2 Instructions Manual page 19

Step 3: Press the +(4)
RAMP ON flashes on
Step 4: Increase or decrease the value of the flashing number by
pressing the +(4)
Step 5: Press the "Enter" (6)
Device then moves to the next adjustable timing option
displayed in the diagram (below), beginning with RAMP ON.
Step 6: Continue moving through each value, changing the value
by pressing the +(4)
accepting the value by pressing the "Enter" Key (6)
there are no blinking values.
Step 7: (Optional) To review the timing option settings without
changing them, use the "Info" Key (7)
settings.
Step 8: You may begin stimulation by pressing the (2) and/or (3)
keys.
Note: The stimulation cannot begin if any value on the LCD screen
is blinking. If a value is blinking on the screen, press the "Enter"
Key (6) until there are no blinking values.
(6)
8.4 Changing PR (Hz), PW (µS) and Waveform Values
To change the "PR" (Pulse Rate Value, measured in Hz), PW
(Pulse Width (measured in µS) or Waveform (SYM = Symmetri cal
Biphasic or ASYM = Asymmetrical Biphasic Waveform)
and/or -(9)
Aand -(9)
RAMP
ON
Delay
key until the numeric value for
the screen.
key to accept the set value.
to scroll through the
RAMP
OFF
CH 2
OFF
18
keys.
keys and/or
until
CH 1
OFF
CH 2
ON