Speed Control Wheel - RADLEY 1281-859 Owner's Manual

Oscillating multi tool - Owner's Manual
ASSEMBLY AND OPERATING
1

SPEED CONTROL WHEEL

The speed of the tool can be adjusted to
run the tool at speeds varying between
10,000 OPM and 21,000 OPM by rotating
the speed control wheel (1) located
Fig.5
toward the rear of the tool housing (Fig. 5).
1. To increase the speed, rotate the
speed control wheel to the right.
2. To decrease the speed, rotate the
speed control wheel to the left.
Speed #1 is the lowest speed.
NOTE:
Speed #6 is the highest speed.
The optimal speed setting will vary
depending upon the type of accessory
being used, the surface being worked
and the complexity of the project. For
general recommendations, see the chart
to the right.
13