Table of Contents
Advertisement
ASSEMBLY AND OPERATING
VARIABLE SPEED CONTROL WHEEL
Set the rotary tool speed by rotating the variable
speed control wheel (1) to the appropriate speed
(Fig. 1). Position the speed control wheel at "1"
for slowest speed, "3" for medium speed and at
"MAX" for the highest speed.
ON/OFF SWITCH
To turn the switch ON, push on the
lower part of the ON/OFF switch (1)
(Fig. 2). To turn the switch OFF, push on the
upper part of the ON/OFF switch (2).
CHANGING THE COLLET
Some accessories require the use of different
sized collets. Collet sizes can be 1/16", 3/32"
and 1/8". It is important to ensure that the collet
size matches the accessory.
NOTE: This tool includes the most commonly
used collets: 3/32" and 1/8".
WARNING: Using a collet that is too large
for the accessory will result in the accessory
possibly being thrown from the tool causing
serious injury.
1. Turn the tool switch OFF and remove the plug
from the power source.
2. Depress the spindle lock button (1) and
slowly turn the collet nut (2) until the spindle
lock button locks the spindle (3) (Fig. 3).
3. While holding the spindle lock button down, turn
the collet nut counterclockwise until it is removed.
4. Remove the collet (4) by pulling it out of the spindle.
5. Insert the replacement collet into the
spindle and replace the collet nut by turning
it clockwise while holding the spindle lock
button down.
NOTE: Do not tighten the collet nut without
an accessory installed in the collet. You will
damage the collet.
13
Rotary Tool Kit - Owner's Manual
Fig. 1
Fig. 2
Fig. 3
Advertisement
Table of Contents
