Variable Speed Control; Trigger Switch; Lock-On Button; Installing The Vacuum Adaptor - RADLEY 1268-536 Owner's Manual

ASSEMBLY AND OPERATING

VARIABLE SPEED CONTROL

Set the jigsaw speed by rotating the
variable speed control wheel (1) to the
appropriate speed (Fig. 7). Rotating the
variable speed control wheel toward the
rear of the jigsaw will result in slower
speeds. Position the speed control dial at
"1" for the slowest speed, "3" for medium
speed and at "6" for the highest speed.
Fig. 7

TRIGGER SWITCH

The trigger switch turns the jigsaw ON
and OFF.
1. To turn the jigsaw ON, squeeze the
trigger switch (1) to start the jigsaw
(Fig. 8).
2. To turn the jigsaw OFF, release the
trigger switch.
(continued)
Fig. 8

LOCK-ON BUTTON

Your jigsaw is equipped with a lock-on feature,
which is convenient when continuous cutting
for extended periods of time is required (Fig.
9). To lock the switch ON, depress the trigger
switch (1), push in and hold the lock-on button
(2) located at the left side of the handle, then
release the trigger. Release the lock-on button
and your jigsaw will continue running. To
turn the jigsaw OFF, depress and release the
trigger switch to release lock.
Fig. 9

INSTALLING THE VACUUM ADAPTOR

To reduce the amount of loose sawdust
produced while cutting, a workshop vacuum
can be attached to the jigsaw by using the
vacuum adapter supplied with the jigsaw.
To install the vacuum adapter (1), insert
the adapter into the vacuum port (2) in the
rear of the jigsaw housing (Fig. 10).
NOTES:
a) The vacuum adapter is slightly tapered. If
the adapter is too large to be inserted into the
vacuum port, insert the opposite end of the
adaptor into the vacuum port.
b) Twist the adapter slightly as it is pressed into
the vacuum port to ensure it is fully inserted.
Fig. 10
1268-536
14