Table of Contents
Advertisement
ACTIVboard User Guide
Wall Mounting Procedure
1. Determine a suitable position for your ACTIVboard
Ideally, this should be a flat and solid wall. Fixing to a wall other than a flat
wall, may require the use of battens or our alternative fixing brackets.
Determine the presence and location of all electrical wiring and pipes
before fixing the brackets.
Wires and pipes may be embedded within the wall. Use a proximity detector to
check the location of these if necessary.
Ensure the brackets will not be fixed within 150mm of any electrical wiring
or pipes.
2. Measure up
Mark the wall with a horizontal line at 950mm from the floor, then mark the
position of the bracket holes according to the dimensions given in the
TP-1443 Installation Leaflet.
3. Prepare wall
For a conventional solid flat wall, drill the bracket holes with a suitable
masonry drill. Other types of wall may require different drill types.
Insert the appropriate plugs. Screw in the brackets as described in the
TP-1443 Installation Leaflet.
4. Fix into position
Two people are required to safely install, move and position the
ACTIVboard.
Before lifting the ACTIVboard into position, ensure the required cables are
connected to the electronics panel on the rear of the ACTIVboard.
Lift the ACTIVboard up parallel with the wall and tilt the board forward
slightly, resting the bottom of the board on the bottom brackets. Take
extreme care to avoid the ACTIVboard falling off the brackets. Align the
brackets on the rear of the ACTIVboard with the wall brackets and then lift
it so that the brackets engage. The ACTIVboard should now slide down
and the bottom should rest in the bottom brackets. Ensure that all
brackets are fully engaged.
6
Advertisement
Table of Contents
