Replaceable Memory - Endress+Hauser TopClean S CPC 30 Operating Instructions Manual

TopClean S CPC 30
Endress+Hauser
5.1.7 Factory setting
All the factory settings are active when the instrument is switched on for the first time.
The table below lists all the main settings. For all further factory settings, please refer to
the "Description of functions" chapter (from p. 34); the factory settings are printed in
bold.
Parameter
Select operating mode
Select measuring principle
Select electrode type
Select connection type
Select temperature display
Select temperature compensation
Temperature measurement
Select temperature sensor
Contact functions
Select current output 1
Select current output 2
Hold
Current
output 1: 0/4 mA value:
20 mA value:
Current
output 2: 0/4 mA value:
20 mA value:
5.2

Replaceable memory

The DAT module is a memory device (EEPROM) which is plugged into the connection
compartment of the transmitter. Using the DAT module you can
•
the complete settings, the logbooks and the data logger of a transmitter and
save
•
the complete settings to other CPM 153 transmitters with identical hardware
copy
functionality.
This considerably reduces the effort to install or service several measuring points.
One-circuit instrument
pH
One-circuit circuit 1
Glass electrode 7.0
Solution ground
Deg. C
ATC
Off
Pt 100
NAMUR
pH/redox K1
Temperature K1
Active with PARAM and CAL
(inactive with DIAG)
pH 2 / –1500 mV / 0.0% / 0.0 °C
pH 12 / +1500 mV / 100.0% /
100.0 °C
Temperature
0.0 °C
100.0 °C
5 Operation
29