GENERAL settings
Auto Scan
SETUP MENU - GENERAL
Auto Chapter Marker
5min.
SP
Record Mode
Auto Scan
Search
Modify Channel
Edit
Sort Channels
OK
Timer Setting Menu
OK
Start auto scan channel.
Manual Program
Manual-Program
Program-Number
P001
Name
C-h-0-0-1
Standard
PAL-B/G
Search-Type
CHANNEL
Band
STANDARD
C---0-5
Channel
Fine-Tuning
Delete-File
Ok
OK
OK
OK
CANCEL
TIPS:
Press to go access the options of an item in the menu.
Press SETUP to exit the menu.
Step 3: Installation and Setup
(underlined options are the factory default settings)
Select to start automatic TV channel programming.
Use keys to highlight { Auto Scan - Search } and
A
press OK .
A warning message will appear.
Select
B
OK
OK
Use keys to highlight { Default TV System } and
press OK, Three modes PAL I , PAL D/K and PAL B/G will
appear, select correct mode , then press OK.
* Hint: The set does not support NTSC TV signal in.
Use keys to highlight { CONTINUE } and press OK on
the remote control.
The automatic TV channel search will start. This process may
take several minutes. Once complete, the total number of
channels found will appear on the TV.
Select to modify your preset TV channels.
Use keys to highlight { Modify channel - Edit } and
A
press OK .
The modify channel options appears.
Use keys to select one of the options and press .
B
{ Program Number } – Use CH+/ CH– or 0-9 keys to select by the
program
number for modifying.
The number of the current channel, this item can not be modified
{ Name }
{ Standard }
{ Search type } –Use
{ Frequency } – Select this to adjust the frequency of the channel.
{ Band }
{ Channel }
{ Fine Tuning }– Select this to fine-tune the TV channel manually if the
{ Delete File}
To confirm the changes, select
C
remote control to exit to the previous screen.
and press OK on the remote control
– Use
to select by the channel name for
modifying.
– Select this to set the system that produces the least
distortion of picture and sound. (See chapter "TV
System Guide" at the back of this manual for
information.)
to select scan mode, there are two mode:
Frequency and channel: To select Frequency mode,
the band item will not be available.
– Use keys to search the next frequency or use
the Numeric keypad 0-9 to change the frequency.
Press OK on the remote control to confirm the
setting.
–The band of this channel, You can select standard or
cable.
– Use
to select and edit channel name.
reception is poor.
– Use keys to fine-tune the frequency.
– Select this to set the channel to be deleted.
OK
OK
(continued)
and press OK on the
25