Advertisement
4. INSTRUCTIONS FOR APPLICATION
F
WARNING! ensure you wear approved safety goggles and any other safety item required for the job. If using conventional chuck,
remove the chuck key before using the drill. Also ensure that all other safety requirements are followed.
p
F
WARNING! In all cases below, be prepared for drill binding or break through. When these situations occur the drill has a tendency
to grab and kick in the opposite direction and could cause loss of control. If you are not prepared this can result in possible damage
p
and/or personal injury. Where possible, place a wooden block under metal work piece at the point where the drill will break through.
4.1.
DRILLING MASONRY, BRICK, STONE, ROCK OR CONCRETE.
The hammer action can be used if required on brick, stone, rock or concrete.
4.2.
CHISEL .... USE on MASONRY, BRICK, STONE, ROCK OR CONCRETE.
F
WARNING! DO NOT USE DRILL MODE, use hammer action only. DO NOT USE WITH CONVENTIONAL CHUCK.
p
4.3.
DRILLING WOOD AND PLASTIC.
DO NOT use the hammer action when drilling wood or plastic materials.
4.4.
DRILLING METAL.
DO NOT use the hammer action when drilling metal.
4.5.
WORK COMPLETE
F
WARNING! drill bits become very hot during use. Allow to cool or hold with a cloth for removal.
p
Advertisement
