Advertisement
Quick Links
IMPORTANT
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE
THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. RETAIN THESE INSTRUCTIONS FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
ELECTRICAL SAFETY. F
1.1.
Electricity At Work Act 1989
Health & Safety at Work Act 1974
Important:
a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.
b) Connect the BROWN live wire to live terminal ‘L’.
c) Connect the BLUE neutral wire to the neutral terminal ‘N’.
After wiring, check there are no bare wires, that all wires have been correctly connected and that the wire restraint is tight.
To re-wire, connect the brown & blue wires as indicated above. DO NOT connect the brown or blue to the earth terminal.
Cable extension reels
1.2
GENERAL SAFETY
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
%
%
%
%
%
%
%
%
WARNING! It is the user’s responsibility to read, understand and comply with the following:
p
You must
If in doubt about electrical safety, contact a qualified electrician.
subject to 1.1.10. below)
Ensure the unit is correctly earthed via a three-pin plug.
Use genuine parts only. Non authorised parts may be dangerous and will invalidate the warranty.
HEAVY DUTY SDS HAMMER DRILL
SDS850
Blue
Neutral
wire
Yellow & Green
Earth wire
Brown
Live
wire
wire
restraint
FUSE RATING
THIS PRODUCT MUST BE FITTED
WITH A:
13 Amp FUSE
Advertisement
Related Manuals for Sealey SDS850
Summary of Contents for Sealey SDS850
- Page 1 HEAVY DUTY SDS HAMMER DRILL SDS850 IMPORTANT PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
- Page 2 2. INTRODUCTION & SPECIFICATIONS Specification SDS850 COMPONENT LIST Figure 1. COMPONENT LIST Figure 2. Items not illustrated. fig 1 INSTRUCTIONS FOR USE 3.1. PREPARING DRILL FOR USE. WARNING! Unplug the drill from the mains power supply before proceeding. Positioning the side handle.
- Page 3 3.2. FITTING THE CONVENTIONAL DRILL CHUCK (See fig.2-D) WARNING! Unplug from the mains power supply before assembling chuck. WARNING! ensure you remove the chuck key before starting the drill. CAUTION! To avoid overloading the motor when using the chuck in the hammer mode, DO NOT apply a too heavy pressure. DO NOT USE CHISELS OR ‘HAMMER’...
- Page 4 Hammer Drill Model SDS850 For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Tools. NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.