Advertisement
Quick Links
IMPORTANT
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE
THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. RETAIN THESE INSTRUCTIONS FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
ELECTRICAL SAFETY. F
1.1.
Electricity At Work Act 1989
Health & Safety at Work Act 1974
Important:
a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.
b) Connect the BROWN live wire to live terminal ‘L’.
c) Connect the BLUE neutral wire to the neutral terminal ‘N’.
After wiring, check there are no bare wires, that all wires have been correctly connected and that the wire restraint is tight.
To re-wire, connect the brown & blue wires as indicated above. DO NOT connect the brown or blue to the earth terminal.
Cable extension reels
1.2
GENERAL SAFETY
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
%
%
%
%
%
%
%
%
!
WARNING! It is the user’s responsibility to read, understand and comply with the following:
p
You must
If in doubt about electrical safety, contact a qualified electrician.
subject to 1.1.10. below)
Ensure the unit is correctly earthed via a three-pin plug.
Use genuine parts only. Non authorised parts may be dangerous and will invalidate the warranty.
HEAVY DUTY SDS HAMMER DRILL
SDS620
Yellow & Green
Earth wire
Blue
Neutral
wire
FUSE RATING
THIS PRODUCT MUST BE FITTED
WITH A:
5 Amp FUSE
Brown
Live
wire
wire
restraint
Advertisement
Related Manuals for Sealey SDS620
Summary of Contents for Sealey SDS620
- Page 1 HEAVY DUTY SDS HAMMER DRILL SDS620 IMPORTANT PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY.
- Page 2 2. INTRODUCTION & SPECIFICATIONS fig 1 COMMON TO MODELS SDE600 Items not illustrated. COMPONENT LIST Figure 1. fig 2 INSTRUCTIONS FOR USE 3.1. PREPARING DRILL FOR USE. WARNING! Unplug from the mains power supply before proceeding. fig 3 3.2. OPERATING THE DRILL Drill without hammer action.
- Page 3 4. INSTRUCTIONS FOR APPLICATION WARNING! ensure you wear approved safety goggles and any other safety item required for the job. If using conventional chuck, remove the chuck key before using the drill. Also ensure that all other safety requirements are followed. WARNING! In all cases below, be prepared for drill binding or break through.
- Page 4 Variable Speed Hammer Drill Model SDS620 For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Tools. NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.