Advertisement
Main
Sub
Contents
code
code
50
19
Duplex copy rear edge void
adjustment
51
02
Resist amount adjustment
53
08
SPF scanning position automatic
adjustment
61
03
HSYNC output check
Used to adjust the rear edge void amount in duplex copy.
(Operating procedure)
When this simulation is executed, the current set value is displayed in two digits.
(Adjustment range: 1 ~ 99, Center value: 50)
*
When the set value is increased by 1, the void amount is increased by about 0.1mm.
Press the copy mode select key to select a suitable setting mode and a display. Enter the adjustment
value with the 10-key and press the [START] key, and the entered value is saved and a copy is made.
(Paper information is cleared after every copying).
When the [INTERRUPT] key is pressed, the entered value is saved and the machine goes into the
sub code entry standby mode. When the [CA] key is pressed, the entered value is saved and the
simulation is terminated.
Lighting lamp
AE lamp
TEXT lamp
PHOTO lamp
Used to adjust the contact pressure of the machine resist roller and the RSPF resist roller onto the
paper.
(Operating procedure)
When this simulation is executed, the current set value is displayed.
When the exposure mode key is pressed, the following set items are changed sequentially. Enter an
adjustment value with the 10-key and press the [START] key, and the entered value will be saved and
a copy will be made. (Adjustment range: 1 ~ 99, Default: 50)
When the [CA] key is pressed, the entered value is saved and the simulation is terminated.
Lighting lamp
AE, Main cassette lamp
AE, 2nd cassette lamp
AE, 3rd cassette lamp
AE, 4th cassette lamp
AE, Manual paper feed lamp
AE, TEXT, PHOTO lamps
AE, TEXT lamps
AE, PHOTO lamp
TEXT, PHOTO lamps
Supported for the installed models only. Skipped for the models without installation.
Place the black chart so that it covers both the SPF scan glass and the OC glass. Close the OC
cover. When this simulation is executed, the current adjustment value is displayed as the initial
display. When the [START] key is pressed, the mirror unit scans from the home position to the SPF
scan position with the current adjustment value displayed, and the SPF glass cover edge is
calculated from the difference between the SPF glass cover edge and the OC side document glass
CCD output level.
*
The default is 50, the adjustment range is 1 ~ 99, and the adjustment unit 1= about 0.127mm.
If the adjustment is completed normally, the adjusted value is displayed. If not, the jam lamp lights up
with the current set value displayed. When the [START] key is pressed again with the jam lamp ON,
the execution is repeated again. When the [Interrupt] key or the [CA] key is pressed during execution,
"- -" is displayed and the operation is canceled. The mirror returns to its home position and the
simulation mode is terminated. In the case when the [Interrupt key] is pressed, the machine goes
into the sub code input standby mode. In the case when the [CA] key is pressed, all the lamps are
turned off.
ON lamp
AE lamp
TEXT lamp
When the [START] key is pressed, HSYNC is performed and the polygon motor is rotated for 30 sec.
Every time when HSYNC is detected, the zoom lamp is lighted for 100msec.
AR-M205 SIMULATIONS 7-19
Details of operation
Paper rear edge void amount (First print surface)
Paper rear edge void amount (Second print surface)
Print start position (duplex back surface)
Adjustment mode
Main cassette paper feed
2nd cassette paper feed
3rd cassette paper feed
4th cassette paper feed
Manual paper feed
RSPF document feed (Front surface)
RSPF document feed (Back surface)
RSPF document (A5) paper feed (Back surface)
Duplex back surface
Display mode
SPF scan position automatic adjustment
SPF scan position manual adjustment
Item
Advertisement
