Main Unit Inspection - HTC Herald Service Manual

7.2 Main unit inspection

7.3.1 System assembly inspection :
-Exposure of substratum is not acceptable for peeling. (Area 4 is included)If not exposure of
substratum, please checked by SPEC. of dot or scratch. (Area 4 is not included)
-Logo may not have blurred or double print., the peeling on logo is not acceptable.
-The character printing of main unit does not allow bad printing,scratch,dirty, lacquer
peeling ,dark/white dot on it)
- Camera lens dot, particle D≦0.25mm；burr ≦1.5mm , W≦0.2mm ,
1. (Gap inspection )
Description
1. Status of main unit assembly.
2. Gap between touch panel and bezel.
3. Gap between upper / lower slid parts.
4. Qwerty key Gap and
Gap between navigation key and
5.
AP keys assembly.
Gap around power button, record
6.
button, volume key, camera button
7. Stylus
Gap between battery cover and
8.
main unit.
HTC confidential
© 2006, HTC CORPORATION. ALL RIGHTS RESERVED.
Defective assembly and deformed shape were nor allowed.
Gap between touch panel and bezel < 0.7 mm
(Skip corner and Enter the material to click)
Gap between upper / lower slid parts < 1..0 mm
Between key Gap<0.35 mm, Edge of key and C-part Gap
around Gap
<0.4 mm
(gap) <0.35 mm
Key stuck are not allowed.
(gap) <0.35 mm
Key stuck are not allowed
Stylus assembly protruding, loose, missing, falling
and deformed is not allowed.
D,E parts(gap) <0.50 mm
A c c e p t c r i t e r i a
TOTAL 58 CONT.ON. 43 PAGE NO. 42
L e v e l
Minor
Minor
Minor
Minor
Minor
Minor
Minor
Minor