Table of Contents
Advertisement
2. Install 11 pop rivets (3/16 x 1/2 inch) and washers
(3/16 inch) to the reinforcement plate, attaching
11-nozzle cover to the 12-nozzle cover
Figure 6
1. 11-nozzle cover
2. Reinforcement plate
3. Using 11 pop rivets (3/16 x 1/2 inch) and washers
(3/16 inch), install the rubber cover and reinforcement
plate (from the 11-nozzle cover) to the 12-nozzle cover
(Figure
7).
Figure 7
1. 11-nozzle cover
2. 12-nozzle cover
3. Pop rivet (3/16 x 1/2 inch)
and washer (3/16 inch)
(Figure
6).
3. Pop rivet (3/16 x 1/2 inch)
and washer (3/16 inch)
4. 12-nozzle cover
4. Rubber cover
5. Reinforcement plate
4
Installing the Center-Boom
Brackets and Cover
Parts needed for this procedure:
2
Center-boom bracket (2014 and earlier models)
2
Boom-mount plate
8
U-nut
8
Hex-head bolt (3/8 x 1-1/4 inch)
1
Model/serial number decal
1
Regulatory decal (119-4986)
8
Flange nut (3/8 inch)
4
Washer plate
8
Hex-head bolt (5/16 x 1-1/4 inch)
4
Center-boom bracket (2015 and later models)
Procedure
Attach the model/serial number decal and the regulatory
decal to 1 of the center boom brackets as shown in
Note: Before applying the decals, clean the decal area and
ensure that it is free of dirt, grease, or other foreign material.
For 2014 and earlier models:
1. Install each of the 2 center brackets and boom-mount
plates to the center boom using 2 hex-head bolts (3/8
x 1-1/4 inch) and 2 flange nuts (3/8 inch) as shown
in
Figure
14.
Note: When mounting the kit to a sprayer, use the
holes in the center bracket to attach the kit to the unit.
When mounting the kit to a vehicle, use the holes in
the boom-mount plate to attach the kit to the unit.
2. Install the center cover to the center-boom brackets
using 4 U-nuts, 2 washer plates, and 4 hex-head bolts
(5/16 x 1-1/4 inch) as shown in
For 2015 and later models:
Important: If you are installing an 11-nozzle assembly,
you will only use 4 U-nuts, 4 hex-head bolts (3/8 x 1-1/4
inch), 4 flange nuts (3/8 inch), 2 washer plates, and 2
center-boom brackets.
1. Install the center cover to the bracket, using 8 U-nuts,
4 washer plates, and 8 hex-head bolts (5/16 x 1-1/4
inch) as shown in
4
Figure
14.
Figure
8.
Figure
14.
Advertisement
Table of Contents
