Protection - Electrolux EACS/I-HAV/N8_22Y EEC User Manual

12
www.home-comfort.com
• Use a dry and soft cloth to clean the
panel. Use lukewarm water (below 40°C)
to flush the panel if the unit is very dirty.
• Never use benzene, solvents or abrasive
products to clean the front panel of the air
conditioner.
• Avoid water penetration on the indoor unit.
In may lead to an electric shock.
Install and close the front panel by pushing
"b" position downward.
Cleaning the air filter
Clean the air filter every 100 hour operation.
The cleaning process:
Turn off the air conditioner and remove the
air filter.
1 Open the front panel
2 Gently pull the filter lever towards you.
3 Remove the filter.
Cleaning and reinstalling the air filter
If it is dirty, wash the filter with a cleaning
solution in lukewarm water. After cleaning,
dry the filter well in the shade. Replace the
filter.
Close the front panel again.
Note:
Rinse the air filter every two weeks if the air
conditioner is operating in a very dirty room.

Protection

Operation conditions
The protection device can automatically turn off
the air conditioner in the following cases::
Mode
HEATING If the outside temperature
is higher 24
If the outside temperature
is lower –25
If the room temperature is
higher 27
COOLING If the outside temperature
is higher 43
If the outside temperature
is lower –15
DRYING If the room temperature is
lower 18
Do not manually adjust the horizontal
blinds, otherwise they may break.
To prevent condensation, do not set the
airflow downward for a long time in the
COOL or DRY operation.
Excessive noise
• Install the air conditioner in a location
strong enough to hold its weight to prevent
noise.
• Place the outdoor unit in a place where the
blowout air and noise from the operation
of conditioner do not bother the neighbors.
• Avoid any obstacles in front of the outdoor
unit to decrease the noise.
Protection features
• When changing the mode or after turning
the air conditioner off and then on again, the
air conditioner compressor starts operation
only in 3 minutes.
• After turning on, the air conditioner performs
self-diagnosis for 20 seconds, and only after
that starts to work.
HEAT mode features
Preheating.
After the air conditioner starts operating in the
HEAT mode, warm air begins to flow only in
2–5 minutes.
The outdoor unit defrosting.
Reason
С
о
С
о
С
о
С
о
С
о
С
о