Use                                                                             22; Removing The Bike                                                               22 - Kayoba 639-446 Instruction Manual

SE GB
7 Place the stabilising unit under the front wheel of the bike (fig 7) The product is now ready
for use (fig 8)
USE
The bike's gears can be combined with the product's 7 resistance levels to produce the desired
resistance Check that the wire to the resistance lever runs free of the wheels and that the bike is
assembled correctly Always check before use that the front wheel is positioned correctly in the
stabilising unit Warm up properly before exercising Ensure the bike's tyres are inflated to the
correct pressure Always keep both hands on the handlebars during use
REMOVING THE BIKE
1 Loosen the resistance lever and wire from the handlebars
2 Lift up the clamping lever (fig 4)
3 Unscrew the end piece from the product's support axle and remove from the bike's rear hub
3) Keep hold of the bike to ensure it does not fall over Remove the stabilising unit from the
front wheel The bike is now free
4 Fold up the product and set it aside (fig 9) Watch your fingers – risk of crush injuries Put
nothing on top of the product
Handle and store the magnetic resistance, lever and cable so that they are not exposed to damage
22
Fig 7