3�2 Amplifier Module Replacement - technetix DBC-1200S User Manual

3.2 Amplifier module replacement
The following modules are hot swappable so can be replaced with the unit powered up�
Note: The modules should be pulled out vertically.
Before changing or swapping the modules or diplexers, connect the amplifier to your laptop with
the USB cable and upload and save the configuration of the amplifier onto your laptop.
When the module(s) have been changed, re-send the saved configuration file to the amplifier.
Upstream module
1� To remove a module, unscrew the two screws holding it in place� Grip the ends of the module and
apply a rocking motion whilst pulling the module at the same time, until it comes out of the housing�
2� To install the module, place it into the downstream slot and push firmly and squarely down onto the
unit until it is fully seated� Secure it by tightening the two screws to a torque value of 13 inch pounds
(1�5 Nm)�
Downstream module
1� To remove a module, unscrew the two screws holding it in place� Grip the ends of the module and
apply a rocking motion whilst pulling the module at the same time, until it comes out of the housing�
2� To install the module, place it into the upstream slot and push firmly and squarely down onto the
unit until it is fully seated� Secure it by tightening the two screws to a torque value of 13 inch pounds
(1�5 Nm)�
04/2019 - AE/V1.16 Technetix Group Limited 30