Amplifier Module Replacement - technetix DBC-1200 User Manual

d. Replace the PSU cover and secure it with 2 x crosshead screws.
e. Apply power and ensure that the PSU green LED is on.

4.2 Amplifier module replacement

The following modules are hot swappable, so can be replaced with the unit powered up.
Note: the modules should be pulled out vertically.
Before changing or swapping the modules or diplexers, connect the amplifier to your laptop with the USB cable
and upload and save the configuration of the amplifier onto your laptop. When the module(s) have been changed,
re-send the saved configuration file to the amplifier.
Downstream
1. Remove a module, unscrew both screws and then grip the ends of the module applying a rocking motion whilst
pulling the module at the same time.
2. To install the module, place it into the downstream slot and push firmly and squarely down onto the unit until it is
fully seated. Secure it by tightening the screws to a torque value of 1.5 Nm.
27 Technetix Group Limited Rev.1._0.1_0217