Table of Contents
Advertisement
9
Programming
2.4 Programming options for the CM
The configuration of the CM must be done by dialling in. This is done by calling the landline
number using the landline telephone* or a mobile phone.
* To call an internal extension, consult the manual of the relevant DECT telephone.
2.5 Setting the CM in programming mode
1
Call the landline number using the landline telephone or a mobile phone.
2
Answer the call by pressing the yellow alarm button on the CM (press once). Enter the
following code on the telephone to put the CM in programming mode: **#
3
The alarm button light will now flash yellow / green.
Now the desired telephone numbers can be programmed. It is recommended to choose a family
member or neighbour for the first two contacts. The last number can be a number that can be
reached 24 hours per day, for example an emergency service.
This way, the first assistance will come from a relative or neighbour, but assistance can always be
called for if the first two contacts don't answer the call.
1x
Code:
** #
Advertisement
Table of Contents
