Initialize Device Parameters (91H) - Toshiba MK6017MAP Product Specification

10.8.14 Initialize Device Parameters (91h)

COMMAND CODE
REGISTER SETTING
DR
CY
HD total number of heads-1
SN number of sector per track
SC
FT
This command specifies the number of sectors per track and the number of heads per cylinder to set head
switching point and cylinder increment point. Specified values affect Number of the current logical heads,
Number of logical sectors per track, which can be read by Identify Device Command.
On issuing this command, the content of CY register shall not be checked. This command will be terminated
with ABORT error when it is issued on a invalid HD or SC register setting ( SC register=0 or the combination
of HD and SC register exceeds the drive parameter.
Any drive access command should accompany correct HD, SN register with heads and sectors within the
number specified for this command. Otherwise, it results in "ID not found" error. If the number of heads
and drives is within the specified number, command gives parameter to convert an address to access into
Logical Block Address (LBA). ' ' ID Not Found' 'error also occur when this LBA exceeds the total number
of user addressable sectors. The command does not affect LBA address mode.
1 0 0 1 0 0 0 1
drive number
Copyright © 2000 Toshiba corporation. All rights reserved.
REGISTER
NORMAL COMPLETION
no change
no change
no change
no change
no change
no change
360014937
-
565 -