Toshiba B-EV4T SERIES Owner's Manual page 30

2. PRINTER SETUP
2.9.2 Self Print Test and
Dump Mode (Cont.)
2.9 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities
The test print contents should be changed by the following commands
and parameters:
PROGRAM VERSION: VX.XX XXXX --- Firmware version and checksum
TONE ADJUST: +XX ------------------------- Print tone fine adjustment value
FEED ADJUST: +XX.Xmm ------------------ Print position fine adjustment value
CUT POSITION ADJUST: +XX.Xmm ----- Cut position fine adjustment value
BACKFEED ADJUST: +XX.Xmm ---------- Back feed amount fine adjustment value
PARAMETER: [PC-850][0] ----------------- Character code selection and Font "0"
[9600][8][1][NONE][2] --- Baud rate, Data length, Stop bit length,
[ON][AUTO][FEED][B0]----- Forward feed wait function, Control code,
X-COORDINTE ADJUST: +XX.Xmm ----- X-coordinate fine adjustment value
SENSOR SELECTION: TRANSMISSIVE - Sensor selection and sensitivity
SENSOR ADJ. VALUE:
TRANSMISSIVE[XX] REFLECTIVE[XX]
PRINT SPEED: 5IPS --------------------------- Print Speed
FLASH ROM:4MB ----------------------------- Flash ROM Capacity
SDRAM: 8MB----------------------------------- SDRAM Capacity
USER MEMORY: [X KB][0 KB] ------------ User Memory Capacity
TTF AREA: [XXXKB][XXXKB]------------ True type font storage area, Main PC board
EXT CHAR AREA: [XXXKB][XXXKB] -- Writable character storage area, Main PC
BASIC AREA: [XXXKB][XXXKB] -------- BASIC file storage area, Main PC board and
PC SAVE AREA: [XXXKB][XXXKB] ----- PC save storage area, Main PC board and
INFORMATION: ------------------------------- Printed only when some information is
TOTAL FEED----------------------------------- Total feed distance
TOTAL PRINT: 0.00 km ---------------------- Total Print distance
TOTAL CUT: 0 --------------------------------- Total Cut Count
IP ADDRESS: 192.168.10.20 -----------------
SUBNET MASK: 255.255.255.0 -------------
GATEWAY: 0.0.0.0 ----------------------------
MAC ADDRESS: XX-XX-XX-XX-XX ----
DHCP: Disabled---------------------------------
DHCP CLIENT ID:
FFFFFFFFFFFFFFFFFFFF FFFFFFFFFFFF
SOCKET COMM.: Enabled-------------------
SOCKET COMM. PORT: 08000-------------
E2-19
ENGLISH VERSION EO1-33087
selection
Parity, and Transmission control of RS-
232C
Feed key function, and Euro code
-- Sensor setting value
and optional memory card
board and optional memory card
optional memory card
optional memory card
stored in the flash ROM
Network setting values
----