Toshiba B-EV4T SERIES Owner's Manual page 26

2. PRINTER SETUP
2.8 Loading the Ribbon
(Cont.)
NOTE: Ribbon Path
Print Head
Ribbon Supply
Roll
3. Push up the Ribbon Access Cover by the portions indicated by
arrows A and fully open it supporting the Print Head Block.
Print Head
Block
4. Fit the Ribbon Take-up Roll to the Spring Guide Wheel and the Guide
Wheel in the same way as the Ribbon Supply Roll.
(1) Push the right side of the core of the Ribbon Take-up Roll against the
Spring Guide Wheel and fit the wheel into the core.
(2) Fit the left side of the core of the Ribbon Take-up Core to the Guide
Wheel, aligning the notch of the ribbon core with the protrusion of the
Guide Wheel.
Guide Wheel
5. Turn the Ribbon Rewind Gear to wind the ribbon leading film onto
Ribbon
the Ribbon Take-up Core until the ink ribbon covers the Print Head,
Take-up
Core and remove any slack of the ribbon.
A
Ribbon
Rewind Gear
E2-15
ENGLISH VERSION EO1-33087
2.8 Loading the Ribbon
Ribbon Access
Cover
A
Spring Guide Wheel
(Take-up side)