Attaching The Tools, Working Notes; Switching On And Off - eisenblatter PTX COMPACT HT Original Instructions Manual

EN
Original instructions PTX COMPACT HT

10. Attaching the tools, working notes

Prior to any conversion work: Pull the mains plug
out of the socket or remove the battery pack from
the machine. The machine must be switched off and at a
standstill.
Tool change:
Only press in the spindle locking button (A1-4 /
B-1) when the spindle is at a standstill!
See page 3, figure B
Attach tools:
1.) Push the support flange (B3) over the M14 thread
mount (B2) and countersink it in the indentations
provided.
Attention: Never mount tools without a support
flange!
2.) Press the spindle lock button (B1) and keep it pressed
while you screw the tool with M14 thread (B4) onto
the M14 thread mount (B2).
Remove tools:
Press the spindle locking button (B1) and keep it pressed
while you unscrew the tool from the M14 thread mount
(B2).
18

11. Switching on and off

Always guide the machine with both hands.
Switch on first, then guide the accessory towards
the workpiece.
Avoid inadvertent starts: always switch the tool off
when the plug is removed from the mains socket
or if there has been a power cut.
The machine must not be allowed to draw in
additional dust and shavings. When switching the
machine on and off, keep it away from dust deposits.
After switching off the machine, only place it down when
the motor has come to a standstill.
In continuous operation, the machine continues
running if it is forced out of your hands. Therefore,
always hold the machine with both hands using the
handles provided, stand securely and concentrate.
Switching on:
Push the sliding switch (A2-3) forwards.
For continuous operation, now tilt it downwards until it
engages.
Switching off:
Press the rear end of the sliding switch (A2-3) and
release it.
www.eisenblaetter.de