Pushing The Wheelchair - Sunrise Medical Quickie Q300 M Mini Instructions For Use Manual

5.8 Pushing the wheelchair

The wheelchair can be moved by pushing. In order to do so,
the motors must be disengaged using a freewheel lever. This
feature was developed for the attendants of wheelchair users
and also functions as an emergency freewheel lever.
The freewheel lever has 2 positions:
1. For driving the wheelchair.
'Drive' position: Turn the lever so that the lever at the drive
wheel side is positioned as shown below (Fig. 5.2 - Fig. 5.3).
2. For disengaging the motors.
'Push' position: Turn the lever so that the lever at the drive
wheel side is positioned as shown below (Fig. 5.4 - Fig. 5.5).
Left-hand side
'Drive'
Left-hand side
'Push'
Q300 M Mini Rev.E
DANGER!
• The free wheel lever should only be operated by the
attendant and never by the user.
• A user may never be left unattended while the wheelchair is
in 'push' (Fig. 5.4 - Fig. 5.5).
• Never set the lever to the 'push' position on a slope!
When the freewheel lever is set to 'push', the automatic
parking brake is deactivated. This makes it possible for the
wheelchair to roll down the slope (Fig. 5.4 - Fig. 5.5).
• The automatic parking brake only works is the lever is set to
'drive' position.
• When the wheelchair is no longer being pushed, the
freewheel lever should be set to 'drive' immediately.
• To manually push the system you must release the motor
brakes.
• Do not engage or disengage motor brakes unless power to
the system is off.
• Make sure you have full control over the system when you
release the motor brakes. When you do so the system will
not have brakes.
• Make sure the system is on level ground before you release
the motor brakes.
• Propel this system by the push handles only. They provide
secure points for you to hold the rear of the system to
prevent a fall or tip-over.
• Check to make sure push handle grips will not rotate or slip
off.
Fig. 5.2
Fig. 5.4
Fig. 5.3
Right-hand side
'Drive'
Fig. 5.5
Right-hand side
'Push'
19