Table of Contents
Advertisement
Site Settings
Use Static Ports
is disabled by
default. This means that the system
will dynamically allocate which ports
to use when opening a TCP/UDP
connection.
Static ports can be enabled by
selecting the checkbox and specifying
the required range of ports.
Port
Range. 3230 to 3270 is the
standard firewall port range. It needs
to be configured according to your
local firewall settings.
NAT. Network Address Translation is
used when the Server is connected to
a router with NAT support. The default
setting for NAT is Off.
If NAT is On, the system will signal
the configured NAT address in place
of its own IP address within Q.931
and H.245.
If NAT is set to Auto, the system will
try to determine whether the NAT
address or the real IP address should
be used for signaling. This is done
to make it possible to make calls
to endpoints on the LAN as well as
WAN.
Changes to any fields in this
section require you to Restart
Service.
Table of
Introduction
Installation
Contents
D13898.06
MAY 2008
The Advanced H.323 Settings
TCS
Backing up and
Quick Setup
Administration
Restoring
Administrator
Conference
Settings
Setup
Conferences
40
TANDBERG
ADMINISTRATOR GUIDE
Restart
Service. (see
Restart Service will terminate calls
that are currently live (that is, the
calls will be ended and conferences
will not be available for on demand
playback).
Before restarting the service, check if
there are live conferences in progress
in the
Live Conferences
check the call status on the LCD
panel of the unit. The
page will also display a warning if
calls are in progress. If you click on
the
Restart Service
are in progress, you will be asked to
confirm if you want to go ahead with
the restart.
NAT
Address. The NAT address must
be the global, external address to a
router with NAT support. In the router,
the following ports must be routed to
the system's IP address:
•
Port 1720
•
The port range specified by the
Port Range
field, eg. 3230 to
3270.
Please contact your TANDBERG
representative or authorized reseller for
more information.
View
Appendices
CONTENT SERVER
Site
Settings)
page or
Site Settings
button while calls
Advertisement
Table of Contents
