Black & Decker BSAH1215AC Instruction Manual page 40

REMOTE CONTROL INSTRUCTIONS
7. iCLEAN
• Press this button with the unit OFF, the remote control will display
"CL" and the unit will automatically clean dust off the evaporator and
dry it, to increase the cooling and heating efficiency.
• The iCLEAN function runs for approximately 30 minutes, during
which if the unit is turned on with the remote control or this button is
pressed again, the iCLEAN will be deactivated.
8. or
• Each time the " " is pressed, the temperature setting will increase by
1°C and each time the " " is pressed, it will decrease by 1°C.
• The setting temperature of the remote control ranges from 16°C~32°C
(60°F~90°F).
NOTE: The temperature cannot be set in AUTO or FAN mode, thus
these two buttons are not functional.
9. TURBO
• Press this button only in COOL or HEAT mode to set TURBO on or off
to speed up the cooling or heating.
• When TURBO is on, the air speed is HIGH.
• When TURBO is off, the air speed will restore to previous status.
10. MODE
• Press this button, you can select the running mode as follows:
NOTE: HEAT mode is not available for cool only units.
11. SLEEP
• Press this button to enter SLEEP mode, which the unit will exit after 10
hours of continuous operation and restore to the previous status.
NOTE: The SLEEP function cannot be activated in Fan mode.
12. SWING
• Press this button to activate up/down swing and press it again to fix
the swing position.
Page 40
AUTO COOL DRY HEAT FAN