Pkm EBO9.4 Instruction Manual page 61

4.1 Replacing of the illuminant
1. Switch off the appliance and disconnect it
from the mains.
2. Unscrew and wash the lamp cover and wipe it dry.
3. Remove the illuminant and replace it by a new one
of the same kind and power:
➢ Heat-proof illuminant for ovens (300
240V/25W/G9 thread /50 Hz.
4. Do not use any other type of bulb
5. Screw the bulb in, making sure it is properly
inserted into the ceramic socket.
6. Screw in the lamp cover.
4.2 Removing of the guides
1. Unscrew the screws of the guides.
2. Rotate the guide vertically to make it leave the side panel.
3. Take the guide out of the side panel hole, using an approx. 45
guide and side panel.
4.3 Removing of the oven door
1. Fully open the door.
2. Fold up the right and left side of locking rod (Picture A).
3. Close the door until reach to stop step, hold on both left and right sides of the door,
then reclose the door, upward and downward and pull out the door.
0 C), 200-
61
0 angle between the