Table of Contents
Advertisement
Examples of Front Panel Operation
Set the IP Address to Static
We strongly recommend that you change the IP
address from DHCP to Static once the Content
Server is in production.
Use the examples on this page together with
the diagram on the previous page to set the IP
address.
To set the subnet mask, default gateway and
DNS IP addresses, follow the steps described
below.
Press
Enter
to produce the menu. The display
shows two lines at a time:
The upper line is the menu title (as shown
here) or a text describing a submenu or
the setting shown (as in the example to
the right). The settings available can be
displayed one by one (the upper line is
retained) by scrolling up and down.
Table of
Disclaimers,
Safety,
Contents
Patents etc.
Environmental
D13898.05
DECEMBER 2007
Press
Enter
to produce the menu. The display
shows two lines at a time:
The upper line is the menu title (as shown
here) or a text describing a submenu or
the setting shown (as in the example to
the right). The settings available can be
displayed one by one (the upper line is
retained) by scrolling up and down.
Example 2: Setting the IP Address Itself
Selecting IP Settings > IP Address
IP Settings
Use the
Arrow
Address Type
keys to scroll up
IP Address
and down and
have the settings
Subnet Mask
shown displayed
Default Gateway
one by one. The
DNS (Preferred)
menu title will be
DNS (Alternate)
retained.
The IP Settings has six submenus. Use
the
Arrow
keys to locate IP Address
Introduction
Installation
Quick Setup
Example 1: Setting the IP Address Type
Selecting IP Settings > Address Type
IP Settings
Use the
Address Type
keys to scroll up
IP Address
and down and
have the settings
Subnet Mask
shown displayed
Default Gateway
one by one. The
DNS (Preferred)
menu title will be
DNS (Alternate)
retained.
The IP Settings has six submenus. Use the
Arrow
keys to locate Address Type
Press
Enter
to enter the submenu:
Press
Enter
to edit the address.
The first digit will now blink.
Use the
Arrow
keys to scroll through the
numbers (0–9) and press
Enter
when the
number requested appears. The next digit will
then start to blink.
Repeat until the final digit has been set.
Backup and
Administrator
Operation
Restoring
18
TANDBERG
Press
Enter
twice to enter the submenu:
Arrow
Static
Use the
Arrow
keys to scroll down to Static.
Press
Enter
to put the change into effect and
proceed to specify the IP address.
Press
Enter
to bypass any digit not in need of
adjustment.
When all digits have been set pressing
produce the Save Changes menu.
Use
Arrow
keys to select applicable option.
Use
Enter
to exit the menu putting changes
into effect.This will take you back to the
IP Settings menu.
If you need to change other settings repeat the
procedure selecting the applicable IP Setting
submenu (e.g. Default Gateway) first.
Use
Return
to leave a menu undoing any changes. This
will also take you back to the IP Settings menu.
Conference
View
Settings
Setup
Conferences
CONTENT SERVER
ADMINISTRATOR GUIDE
Enter
will
Appendices
Advertisement
Table of Contents
